Hettich HettCube 60 Bedienungsanleitung Seite 108

Operation
6 Operation
24 / 82
DANGER
A danger is posed by penetrating liquids.
There is an electric shock hazard for personnel.
−
If liquid has penetrated the incubator during oper-
ation, do not touch the incubator and switch it off
on the building side (e.g. via the fuse).
−
In such a case, contact a service technician of the
manufacturer.
WARNING
There is a risk of incorrect temperature control of the
samples.
There is a risk of incorrect temperature control of
microbiological samples, which can lead to misinter-
pretation of the test results or destruction of the sam-
ples.
−
Arrange for maintenance and calibration to
be carried out ⮫
on page 67 .
−
Note the information in this manual concerning
the effect of heat generation from auxiliary equip-
ment operated in the incubator.
−
Bear in mind the temperature change profile.
−
Do not place microbiological samples on the incu-
bator floor. Use the shelves.
−
Position the microbiological sample material within
the usable space.
−
Comply with the permissible ambient conditions.
−
Prevent the incubator from being exposed to
direct sunlight.
−
Close the incubator door when not inserting or
removing samples.
−
After a power failure, check to ensure that the
samples are still suitable for use.
CAUTION
A hazard is posed due to the improper pulling-out or
pushing-in of the various slide-in modules or drawers.
Avoid strong acceleration.
−
Carefully pull out or push in slide-in modules,
drawers or applications.
02.2023 / Rev. --
Chapter 7.5 'Maintenance'
AB69601en