Problems And Troubleshooting - NEO TOOLS 75-203 Gebrauchsanweisung

neo-tools.com neo-tools.com
AUTOMATIC HEIGHT MEASUREMENT
Switch on the device and swipe left/right to choose the automatic height
measurement mode
the measurement reference point.
Press the measurement button (2) and measure length of the upper side of the
triangle, indicated in red on the range finder screen. Next measure the bottom side
of the triangle in the same way. Based on the side lengths and the angle measured
by the range finder, it will automatically determine height (vertical distance
between measurement points).

PROBLEMS AND TROUBLESHOOTING

The device displays errors using error codes. The table below shows code
descriptions and solutions.
Error code
204
Calculation error
208
Too high current
220
Depleted battery
252
Too high temperature
253
Too low temperature
255
Too weak
measurement
signal/too long
measurement time
256
Too strong
measurement signal
261 Beyond
measurement range
500
Software error
.. Scroll up/down and choose measurement unit and
Cause
Repeat the measurement
accordingly to the manual
Contact the manufacturer
Replace batteries
Let the device cool down to
temperature below 40°C
Warm up the device to temperature
above 0°C
Use aim board or make
measurements using surface that
reflects light
Use aim board or make
measurement on less illuminated
surface
Choose measurement point in the
measurement range
Switch the device off and on. If the
display still shows the code, contact
the manufacturer
19
Solution