Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
neo-tools.com
HOW TO MAKE A SINGLE MEASUREMENT
Use the ON switch (2) to switch the device on, it automatically sets to single
measurement mode. Press the ON button (2) to make single measurement.
HOW TO MAKE CONTINUOUS MEASUREMENT
Use the ON switch (2) to switch the device on, it automatically sets to single
measurement mode. Press and hold the ON button (2) for approximately 3 seconds
to make continuous measurement. The device will be showing measured values
constantly. Press the ON button (2) shortly to store the result of the continuous
measurement and the device will switch to the single measurement mode.
HOW TO MEASURE AREA
The area measurement mode is used to measure rectangular areas. Use the ON
button (2) to switch on the device, then press the UNITS button (3) to switch on the
area measurement mode. Press the ON button (2) to measure one of the sides of a
rectangle. Make the measurement of the second rectangle side in the same way.
The result shown is the rectangle area.
HOW TO MEASURE VOLUME
The volume measurement mode is used to measure rectangular cuboid volumes.
Press the ON button (2) to switch on the device, then press the UNITS button
(3) twice to switch on the area measurement mode. Press the ON button (2) to
measure one of the cuboid edges. Make the measurement of the other two cuboid
edges in the same way The result shown is the rectangular cuboid volume.
PROBLEMS AND TROUBLESHOOTING
The device displays errors using error codes. The table below shows code
descriptions and solutions.
Error code
204
Calculation error
208
Too high current
220
Depleted battery
252
Too high temperature
253
Too low temperature
255
Too weak
measurement
signal/too long
measurement time
256
Too strong
measurement signal
261
Beyond
measurement range
Cause
Repeat the measurement
accordingly to the manual
Contact the manufacturer
Replace batteries
Let the device cool down to
temperature below 40°C
Warm up the device to temperature
above 0°C
Use aim board or make
measurements using surface that
reflects light
Use aim board or make
measurement on less illuminated
surface
Choose measurement point in the
measurement range
13
Solution
Werbung
Inhaltsverzeichnis
