Scope Of Delivery; Use - Intenso Magnetic Wireless Charger MB1 Bedienungsanleitung

SCOPE OF DELIVERY

Intenso Magnetic Wireless Charger MB1/MW1
1
Power supply HP8
2
Please check whether the packaging contents (see also diagram at the beginning of
the manual) are complete and undamaged. If this is not the case, please contact the
seller or our service department:
rma@intenso-international.de

USE

Start-up / charging compatible devices
Step 1: Preparation
Connect the integrated USB-C cable to the power supply unit and next connect the
power supply unit to a power socket (observe the safety instructions).
Step 2: Start charging
Position your Qi-compatible device in the centre of the inductive charging station.
The charging process starts automatically.
If this is not the case, please check
a. whether your device is Qi-compatible
b. whether there is a foreign object between the devices or you are using an
unsuitable case.
c. whether you have chosen the enclosed power adapter or a different but com-
patible one. If this is not the case, replace it accordingly. If this is the case,
please disconnect it from the power supply for a few seconds and reconnect
it to start the charging process.
d. whether the cable ends and the power supply unit are correctly connected.
e. where the correct wireless charging position is on your device. You may need
to reposition it.
Please note that the ambient temperature and the charging electronics of the device
to be charged have an effect on the charging behaviour over which the inductive
charging station itself has no influence. For example, the charging speed may be
reduced at increased temperatures or when charging levels have already been rea-
ched.
Step 3: End charging process
To end the charging process, simply remove your device from the inductive charging
station.
Instruction manual
3
EN - Page 4 of 5