TFA 30.3065 Bedienungsanleitung Seite 14

TFA_No. 30.3065_Anl_02_23
Wireless thermometer
7.2.2 Maximum and minimum values with auto reset
• Press the HI / LOW button to enter the automatic reset mode of
the maximum-minimum values.
• HI / LOW 24 HR appears on the display.
• This mode displays the maximum and minimum values meas-
ured in the last 24 hours. When a reading is older than 24
hours, it is replaced with the next higher or lower reading that is
still within the current 24-hour time window.
• Note: The highest and lowest values are not simultaneously
reset to the current measurement at a specific time.
• Manual reset is also possible.
8. Positioning and mounting of the base station and the trans-
mitter
• The base station can be placed onto any flat surface (foldout
stand) or wall mounted (mounting hole) at your chosen loca-
tion. Make sure you avoid the vicinity of any source of interfer-
ence such as computer screens, TV sets or solid metal objects.
• The transmitter can be wall mounted (mounting hole at the
back). When placed outdoors, choose a shady and dry place for
the transmitter. Direct sunlight may trigger incorrect measure-
ment and continuous humidity damages the electronic compo-
nents needlessly.
26
26.02.2023 11:46 Uhr Seite 14
Wireless thermometer
• Once the desired location is chosen, check whether the trans-
mission from the transmitter to the base station is possible
(transmission range of up to 80 m in open areas). Within solid
walls, especially ones with metal parts, the transmission range
can be reduced considerably.
• If necessary choose another position for the transmitter and/or
base station.
9. Care and maintenance
• Clean the devices with a soft damp cloth. Do not use solvents
or scouring agents.
• Remove the batteries if you do not use the devices for a long
period of time.
• Store the devices in a dry place.
10. Troubleshooting
Problem Solution
➜ Ensure that the battery polarity
No indication
on the base station
➜ Change the battery
is correct
27