Connecting Group Play Mode - Samsung MX-ST90B Bedienungsanleitung

Connecting Group Play Mode

You can connect multiple audio systems in a wired group play mode to create a more interesting party
environment and to produce higher sound output.
Connecting the wired Group Play mode
1st
Sound Tower HOST
Connect the analogue audio cable to the OUT(Group Play) of the HOST.

※ Sound Tower HOST can play music from any source.
Connect the analogue audio cable to the IN(AUX2) of 2nd Sound Tower and Set the source to AUX2.

Set up Group Play by connecting all the systems using analogue audio cables.

Use the AUX or
the Sound Tower HOST.
• Set one Sound Tower as the HOST and any music played on it will be shared among any other
Sound Tower in the Audio group.
NOTES
• Analogue audio cables are not supplied.
• Depending on the length or characteristics of the cable, there may be a difference in operating
distance.
• Be sure to select the Audio In function on the last system.
• In this configuration, the sound from the last system may lag behind others.
• To stop Wired Group Play:
– Remove analogue audio cable from the HOST
– Change to a source other than AUX2 on any Sound Tower in the group besides the HOST
– Turn off the HOST
• If the Wired Group Play function does not start:
– Check the connections.
– Ensure the audio cables are connected correctly.

2nd
Sound Tower
(Source) button to change the source to AUX2 for every Sound Tower except
RCA cable
(not supplied)

AUX2 white LED on AUX2 white LED on
Continue these steps to
connect Sound Towers
until the last one is
connected.
ENG - 9

Last
Sound Tower