Important Warnings - Zelmer ZCM6255 Benutzerhandbuch

EN
PL

IMPORTANT WARNINGS

Any incorrect use or improper handling of the product shall render the warranty null and void.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the
product label.
The mains connection cable must not be tangled or wrapped around the product during use. Do not use the
device, or connect and disconnect to the supply mains with the hands and / or feet wet.
Do not pull on the connection cord in order to unplug it or use it as a handle.
Never use your coffee machine without water in it.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact an
official technical support service.
In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from the
brand's Official technical support service may carry out repairs or procedures on the device.
B&B TRENDS SL disclaims all liability for damages that may occur to people, animals or objects, for the
non-observance of these warnings.
THE FIRST TIME USE AND PREHEATING
To ensure the first cup of coffee tastes excellent, we recommend you should preheat and rinse the machine.
Purified water is preferred.
1. Open water tank cover, fill water into water tank, water level should not exceed the MAX line. Set up the
water tank vertically and align the buckles to the hole on the back of the machine, and press it down to be
parallel to the top of the machine.
2. Set steel mesh into the metal funnel (without coffee in steel mesh), make sure the tube on funnel aligns
with groove in the appliance, then insert the funnel into the appliance from the "UNLOCK" position, and fix
them into coffee maker firmly by turn it anticlockwise until it is at the "LOCK" position.
3. Place a mug or jug on removable cup shelf, make sure the steam control knob is at the OFF position.
4. Plug in the power source or connect the appliance from the mains supply, press power button, power
button is illuminated solidly, the 1 cup button, 2 cup button, and manual button will pulse as the machine
begins preheating. When the 1 cup button, 2 cup button and manual button illuminate solidly, the preheating
is finished.
5. Press manual button, the appliance will pump water for about 30s, water will pass through the system,
then pour out in the mug and clean them thoroughly. Dispose of the water and repeat the process a further
3 times or more.
Place the steam wand into a mug or jug and slowly turn the steam control knob until water dispenses, keep
the steam control knob open for at least 30 seconds and close the steam control knob. Take care performing
this process as the hot water will pulse into the receptacle, and it may emit steam.
Now the appliance is ready for making coffee.
Note:
If preheating is not completed yet, press the 1 cup button, 2 cup button, or manual button, the pump does
not work.
During water flowing out, before the receptable is full, press the manual button again to stop pumping water
immediately.
There may be noise when pumping water for the first time or after a long time not used, it's normal that
appliance is releasing the air inside. After about 20s, the noise will disappear.
For manual button, working time is MAX 120s, unit will automatically stop working if no any operation within
120s.
13