Post Flight; Motor Service; Servo Service; Troubleshooting Guide As3X - Horizon Hobby E-FLITE Slow Ultra Stick 1.2m Bedienungsanleitung

EN

Post Flight

1. Disconnect the flight battery from the ESC (required for safety and
battery life).
2. Power OFF the transmitter.
3. Remove the flight battery from the aircraft.
4. Repair or replace all damaged parts.

Motor Service

CAUTION: Always disconnect the flight battery before performing motor service.
Disassembly
1. Remove the spinner (A), screw (B), spinner retainer (C), propeller nut (D) and
propeller (E).
2. Remove the 4 screws (F) from the propeller shaft (G).
3. Remove the propeller shaft from the prop adapter.
4. Remove the 2 screws (H) from the motor mount (I) and the fuselage.
5. Disconnect the motor wires from the ESC wires.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• Install the propeller with the size numbers (11 x 5.5) facing forward.
• Tighten the propeller nut using a 10mm wrench.
• Push the rubber spinner back on to the plastic spinner retainer.

Servo Service

Control Surface Replacement Servo
Aileron (1)
Elevator (1) SPMSA345SL
Rudder (1)

Troubleshooting Guide AS3X

Problem
Damaged propeller or spinner
Imbalanced propeller
Motor vibration
Oscillation Loose receiver
Loose aircraft controls
Worn parts
Irregular servo movement
Trim is not at neutral
Inconsistent flight Sub-Trim is not at neutral
performance
Aircraft was not kept immobile for
5 seconds after battery connection
Incorrect response to the Incorrect direction settings in the
AS3X Control Direction Test receiver, which can cause a crash
Throttle not at idle and/or throttle
trim too high
Aircraft will not respond
Throttle servo travel is lower than
to throttle but responds to
100%
other controls
Throttle channel is reversed
Motor disconnected from ESC
18
Possible Cause
Replace propeller or spinner
Balance the propeller.
Replace parts or correctly align all parts and tighten fasteners as needed
Align and secure receiver in fuselage
Tighten or otherwise secure parts (servo, arm, clevis, horn and control surface)
Replace worn parts (especially propeller, spinner or servo)
Replace servo
If you adjust trim more than 8 clicks, adjust the clevis to remove trim
No Sub-Trim is allowed. Adjust the servo linkage
With the throttle stick in lowest position. Disconnect battery, then reconnect battery and keep the
aircraft still for 5 seconds
DO NOT fly. Contact Product Support for a solution.
Reset controls with throttle stick and throttle trim at lowest setting
Make sure throttle servo travel is 100% or greater
Reverse throttle channel on transmitter
Make sure motor is connected to the ESC
5. Store the flight battery apart from the aircraft and monitor the
battery charge.
6. Make note of the flight conditions and flight results, planning for future flights.
E
D
B
C
A
Description
A345SL 9g Sub-Micro Digital Servo
Solution
Slow Ultra Stick 1.2m
H
I
G
F
Wiring not shown