Suntec Wellness KLIMATRONIC Night Sun Bedienungsanleitung Seite 9

is accessible.
If the supply cord is damaged, do not use the
•
appliance further and contact your seller.
The heater must not be located immediately below
•
a socket outlet.
Do not use this heater with a programmer, timer or
•
any other device that switches the heater on
automatically, since a fire risk exists if the heater is
covered or positioned incorrectly.
Do not place the appliance close to curtains and
•
other combustible materials.
Please use clamps to avoid pulling on the cable
•
and thus preventing the appliance from tipping
over.
Do not use multiple sockets or extension cords.
•
• Warning: In order to avoid overheating, do
not cover the heater!
Part Description (1)
1
Heating Element Assembly
2
Knob
3
Body
4
Position Indication Plate
5
Pull Switch
6
Tube Cover
7
Upper Post Assembly with inner adjustable pole
8
3 - M5X6 Screws
Installation (2)
Before installing your appliance, you must disconnect the electrical supply at the circuit breaker.
-
Insert the lower post assembly (11) into the base assembly (16) and then fix it tightly with the 4
M6X30 screws (15). Then insert the first clamp (12) into the lower post (11) (see fig.1).
-
Join the Lower Post Assembly (11) and the Middle Post (9) together with 3 M5X6 screws (10) (see
fig.2). Insert the second clamp to the Middle Post.
-
Join the Upper Post Assembly (7) and the Middle Post (9) together with 3 M5X6 screws (8) (see
fig.3). Insert the third smaller clamp to the Upper Post.
-
Join the Heating Element Assembly (1) with the Upper Post Assembly (7), then fix them tightly by
rotating the knob and put the power cord (13) into the clamps (12) (see fig.4).
-
The Heating Element Assembly can adjust its angle between 0º and 45º depending on your needs
(see fig.5).
Operation
The appliance is switched on by means of the pull switch (5). The slight vibration noticeable when the
appliance is switched on will stop after a few seconds.
Output
9
Middle Post
10
3 - M5 X 6 Screws
11
Lower Post Assembly
12
3 Clamps
13
Power Cord
14
Base Cover
15
4 - M6X30 Screws
16
Base Assembly