Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C
The ALDEBARAN® HERO is delivered ready for connection with supply cable and plug. The LED spotlight must only be
connected to alternating current – with voltage according to the type plate – to a properly installed protective contact
socket. Please ensure that your installation complies with the relevant VDE guidelines. If you have any questions in this
regard, please contact your energy supplier or your electrician. We are, of course, at your disposal should you have any queries.
ATTENTION!
In the case of versions of the LED spotlight with other plug-in systems (not Schuko®), the voltage according to the
rating plate must be observed.
WARNING!
• Lay the cables in such a way that there are no tripping hazards and they are protected from mechanical damage
such as tearing off or being run over.
• If necessary, secure the cables with tape or cable ties.
• Make sure the LED spotlight is securely set up and fastened before use.
• Also observe the applicable regulations on occupational safety!
WARNING! Risk of injury!
Make sure that your attachment is secured against detaching by itself.
Loosening and falling of the product from the mast can cause personal injury.
12
A
D
B
Initial operation
Installation / Mounting
Controls
(A) Light module
(B) Individual mast mounting
(C) Pneumatic light mast
(D) Turn-swivel unit
(E) Carabiner
E
Werbung
Inhaltsverzeichnis
