Aqua Forte RD352 Gebrauchs- Und Installationsanleitung Seite 9

180s to redefine the flow range of the system.
User can press
perform self-learning for 180s after the next restart.
5.4 Backwash
User can start the backwash or fast re-circulation in any running state by pressing
Time
Running capacity
If backwash is completed or disabled, press and hold
to the normal operating state before backwash.
5.5 Manual-Inverter Mode
1
2
3
4
5.6 Auto-Inverter Mode
Under Auto Inverter Mode, the pump could automatically detect the system pressure and adjust
the speed of motor to reach the set flow.
1
for more than 3 seconds to exit the manual self-priming, the pump will
Default
180s
100%
Hold for more than 3 seconds to unlock the screen;
The pump will run at 80% of the running capacity after
Press to start.
self-priming.
Press or to set the running capacity between 30%~100%, each
step by 5%
Press again to switch to Auto-Inverter mode.
Unlock the screen, press
Auto-Inverter mode.
Setting range
Press or to adjust from 0 to 1500s with 30
seconds for each step
80~100%, enter the parameter setting (see 5.8)
for 3 seconds, the pump will return
to shift from the Manual-Inverter mode to
.
7