Parameter Setting - Aqua Forte Rd352 Gebrauchs- Und Installationsanleitung

Note:
When timer mode is activated, if the set time period contains the current time, the pump will start
running according to the set running capacity or flow rate. If the set time period does not contain
the current time, the timer number
will be displayed on the controller and flash,
corresponding time period, indicating a successful timer setting.
All 4 time periods should be set in chronological order. Overlap setting of time will be considered
as invalid, the pump will only run based on the previous valid setting. If all 4 time periods set by
the timer are invalid,
press to reset the time period again to make sure they are valid.
During timer setting, if you want to return to the previous setting, hold both
seconds. If you don't need to set all 4 timers, you can hold
automatically save the current set value and activate the timer mode.

5.8 Parameter Setting

Restore factory setting
Check the software
version
Manual priming
Enter parameter
setting as below
(or 1 or 2 or 3 or 4) that is about to start running
and
Under off mode, hold both
Under off mode, hold both
Under on mode, hold both
Under off mode, hold both
address does no need to be adjusted, hold both
next address
will display the
will flash to remind the user, you can
for 3 seconds, the system will
for 3 seconds
for 3 seconds
for 3 seconds
for 3 seconds; If current
for 3
to
9