To Replace The Blade; Troubleshooting - Husqvarna Aspire LC34-P4A Bedienungsanweisung

• Clean the surfaces of the battery and the battery
charger with a soft and dry cloth.
To examine the cutting equipment
WARNING:
turn the safety key to 0, remove the battery
and wait a minimum 5 seconds.
WARNING:
when you do maintenance on the cutting
equipment. The blade is very sharp and cuts
can easily occur.
1. Examine the cutting equipment for damage
or cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note:
It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes
the product to stop, replace the damaged blade. Let the
service center estimate if the blade can be sharpened or
must be replaced.

To replace the blade

Technical data on page 22 for the correct type
Refer to
of blade.
WARNING:
of wood to prevent injury to fingers when
Troubleshooting of the battery charger
LED on the battery
charger
The green LED is
on and the red LED
flashes.
The red LED is on
and the green LED is
off.
18
To prevent accidental start,
Use protective gloves
Lock the blade with a block

Troubleshooting

Cause
The battery is not correctly instal-
led in the battery charger.
The battery connectors are dirty.
The charger has identified an in-
ternal error.
The battery is defective.
The battery temperature is out-
side of the charging range.
you replace the blade. The blade can be
moved when the motor is off and fingers
can become trapped between the blade and
stationary parts.
1. Lock the blade with a block of wood. (Fig. 42)
2. Remove the blade bolt.
3. Remove the blade.
4. Examine the blade support and blade bolt to see if
there are damages.
5. Examine the motor shaft to make sure that it is not
bent.
6. When you attach the new blade, point the angled
ends of the blade in the direction of the cutting cover.
(Fig. 43)
7. Make sure that the blade is aligned with the center of
the motor shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer with a
torque of 23-28 Nm. (Fig. 44)
9. Pull the blade around by hand and make sure that it
turns freely.
WARNING:
The blade is very sharp and cuts can
easily occur.
10. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration in
the product or the cutting result is unsatisfactory.
Solution
Remove the battery from the charger and install the bat-
tery in the battery charger again.
Clean the battery connectors.
Ensure that all batteries are fully inserted. Remove the
mains plug and reinsert. If the error occurs again, have
the charger checked by an authorised after-sales service
centre for Husqvarna products.
Replace the battery.
Wait until the battery temperature is back within the per-
mitted charging temperature range (0-45°C).
Use heavy duty gloves.
1848 - 004 -