BOMANN GSPE 7415 VI Bedienungsanleitung, Garantie Seite 31

• Adjust the front feet (b) with a wrench until the
dishwasher is level.
Fixing the dishwasher
Fix the appliance with the enclosed screws in the
holes provided.
A If the worktop is made of wood, fasten the appli-
ance to the worktop.
B If the worktop is made of marble or granite, fasten
the appliance to the side with the cabinet unit.
Put on the screw cover caps.
Water connection
CAUTION:
• Installation to the water supply must be carried
out in accordance with local laws and regulations.
• The appliance is not suitable for hot water supply.
• Use the new hose set supplied to connect the
appliance to the water supply. Do not reuse old or
used connection sets.
• If the water supply is new or has not been used
for a long time, make sure that the water is clear
and free of impurities before connecting it to the
water supply.
NOTE, the connection to the water mains may only
be made in accordance with DIN EN 1717 of the
drinking water ordinance. A suitable safety device
against drinking water contamination through back-
flow must be installed.
Notes on inlet hose safety system
(delivery scope depending on model)
The safety system consists of a double-walled inlet
hose. It guarantees to cut off the water supply when
leakage of the inner hose. Switching off the water
supply leads over an electronic contact.
If necessary, you can order an inlet hose safety sys-
tem from your dealer or in our online accessories
shop, www.bomann-germarny.de. To order, use the
reference number found under
Connecting the water inlet hose
(cold water connection)
NOTE:
The water pressure must be between 0.04-1.0 MPa.
For higher water pressure: connect pressure reduc-
ing valve upstream.
• Connect the water inlet hose to a
water thread with ¾". Tighten the
hose in the direction of the screw
thread; make sure it is firmly
seated.
• Connect the other end of the inlet
hose to the inlet valve on the rear
of the appliance; also ensure that
it is firmly seated.
Connecting the water drain hose
NOTE:
The water drain hose is approx. 1.5 m long and can
be extended to max. 4 m with a suitable hose and
connector.
CAUTION:
To prevent dirty water from flowing back, the free end
of the hose must not be below the water level of the
drain.
31
"Technical data"
.