Before First Use; Location; Intended Use; Inserting The Batteries - Westfalia 94 53 07 Originalanleitung

Before first Use

Remove it from the packaging and check it for damage in transit.
Remove the foil from the surfaces!
Keep packaging materials out of reach of small children. There is
risk of suffocation!

Location

 Select a setup location in a closed room.
 Handle the article with care. It can be damaged by impacts,
blows, or accidental drops, even from a low height. Avoid strong
vibrations and magnetic fields (in the vicinity of machinery or
loudspeakers).
 Avoid unfavorable conditions when installing the article, such as:
excessive humidity or damp (e.g. bathroom), extreme cold or
heat, dust, flammable gases, fumes or solvents.
 When mounting the article on a wall make sure to check for
electric wires, gas or water pipes inside the wall. Otherwise there
is a danger of electric shock when drilling the holes.
 The article comes with a fold-out foot on the rear and a slot for
wall mounting.
 If possible select a position in which the article is not exposed to
direct sunlight.
 For easier handling and operation set the article up on ist foot
(7). Open the foot carefully.

Intended Use

The article is intended to measure temperature and humidity inside
rooms. The article is only intended for domestic use and not for
commercial operation.

Inserting the Batteries

1. Open the battery compartment (9) at the rear side of the unit and
insert two new 1.5 V batteries of the type LR03 (AAA) into the
battery compartment. Pay attention to the proper polarity of the
batteries. All available icons appear for several seconds on the
display for confirmation and you will hear a signal sound.
Operation
15