Before First Use; Sensors - Inserting/Replacing The Batteries; Reset Button; Basis - Inserting/Replacing The Button Cells - Westfalia 87 84 90 Originalanleitung

Before first Use

Remove the devices from the packaging. Keep packag-
ing material out of reach of children. There is a risk of
suffocation!
Sensors – Inserting/replacing the Batteries
1. Open the battery com-
partments of the sensors
and insert two batteries of
the type LR6 (AA) into the
compartments, observing
correct polarity. The po-
larity symbols are shown
inside the compartments.
2. Close the battery com-
partments again.
Replace the batteries if there is no signal. If the wire-
less signal is transmitted, the red LED of the sensor
will light up every 30 seconds.

RESET Button

The RESET button (1) is also located under the battery
compartment lid. In case of failure, to clear all readings,
push the button with a spiky object.
Basis – Inserting/Replacing the Button Cells
1. Pull the battery transportation foil. All segments on
the display will light up for 3 seconds and the basis
will start searching for the signal of the sensors.
Operation
1
2
13