Installation; Safety; General Safety Instructions; Regulations, Standards And Instructions - STIEBEL ELTRON SBP 1000 E Bedienung Und Installation

INSTALLATION

Safety

INSTALLATION
6. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1

General safety instructions

We can only guarantee trouble-free function and operational reli-
ability if original spare parts intended for the appliance are used.
6.2

Regulations, standards and instructions

Note
Observe all applicable national and regional regulations
and instructions.
7.

Appliance description

7.1

Standard delivery

Delivered with the appliance:
- additional type plate
only SBP 1010 E:
- Insulation set for blank flange (nominal diameter DN 80)
7.2

Accessories

7.2.1 Required accessories
Depending on the static pressure, safety assemblies and pressure
reducing valves are available. These type-tested safety assemblies
protect the appliance against unacceptable excess pressure.
7.2.2 Further accessories
In addition, heat exchangers, flanged and threaded immersion
heaters and thermal insulation are available as accessories.
18 | SBP 1000-1500 E | E SOL | E cool
8.

Preparations

8.1

Installation site

f Always install the appliance in a room free from the risk of
frost.
f Ensure the floor has sufficient load bearing capacity and
evenness (see chapter "Specification / Data table").
f Observe the room height and height when tilted (see chapter
"Specification / Data table").
Minimum clearances
≥200
f Maintain the minimum clearances.
8.2

Transport

Use the lifting eyes at the top of the appliance to assist handling.
≥200
www.stiebel-eltron.com