Inhaltsverzeichnis
Werbung
9.2
Replacing pads
1. Remove first the inner pad and then the outer pad
from each arm support. The pads are held in place
in the arm supports by burr fasteners.
2. Install the new pads in reverse sequence in each arm
support. Make sure that the pads are fitted right way
round.
The pads and the arm supports are color-
coded, with a blue dot for left and a red dot for
right.
9.3
Replacing arm-support strap
1. Open the burr fasteners at both ends of the arm-
support strap.
2. Remove the strap from the two tabs of the arm
support.
3. Position the top part of the magnetic catch at the
parked position on the arm support.
4. Starting from below, pass the new strap through the
first tab. The burr fastener must face out.
*2339613*
2339613
English
33
Werbung
Inhaltsverzeichnis
