Connecting The Connection Cable - Sony GB-5A Bedienungsanleitung

〈8〉 Connecting the connection cable
• Connect the round connector (male) on the scale unit
side with the round connector (female) on the connection
cable side.
• For the GB-A series, connect the enclosed connection
cable (CH01 series).
• For the SR127/SR128 series, connect an optional
connection cable.
Note
• For the GB-A series, be sure to connect the cable so that
the serial No. of the scale unit matches the combination
No. of the connection cable.
• When the SR127/SR128 series and optional connection
cable (CH01 series) are procured together in the electrically
adjusted condition, connect the cable so that the serial No. of
the scale unit matches the combination No. of the connection
cable in the same manner as for the GB-A series.
• When procuring the optional connection cable (CH01 series)
separately, be sure to perform the electrical adjustments.
• Connect the connectors so that the notches on both ends
match. Then rotate the tip (part A - coupling nut) of the round
connector (male) on the scale unit side lightly by hand in the
direction of arrow 1 until it stops. Next, attach wrenches to
part A and female connector part B and rotate the coupling
nut an additional 3/4 of a revolution to screw it into the
female side. The tightening torque at this time should be
approximately 150 to 250 N•cm.
Connection
Notch
cable side
(Female side)
Part A
Part B
1
Connection
cable side
(Female side)
Fig. 3-16
Note
• Use a wrench or other tool to tighten the connectors to a
torque of 150 to 250 N•cm.
• Do not tighten the connectors by attaching wrenches to parts
A and C.
• To disconnect the connectors, attach wrenches to the male
connector part A (coupling nut) and part C and rotate the
coupling nut in the direction of arrow 2.
• Do not loosen the connectors by attaching wrenches to parts
A and B.
Scale side (Male side)
Part C
Scale side (Male side)
Coupling nut
2
55