Cameo X3 TW Bedienungsanleitung Seite 17

SYSTEM SETTINGS (Settings)
Ausgehend von der Hauptanzeige gelangen Sie durch Drücken auf den Encoder in das Hauptmenü.
Select the Settings menu item and confirm the selection.
This will take you to the submenu for setting the submenu items. See table (rotate the encoder to
select and push the encoder to confirm selection, change value or status by rotating, confirm by
pressing encoder.
Settings
Display = Rotate display
Reverse
Display Off = Display lighting
Timer
DMX fail = Operational status
with DMX signal
fault
= Dimmer curve
Dimmer
curve
OFF No display rotation
ON Display is rotated by 180° (e.g. for over-
head installation)
Off after Deactivates after approximately 20
20s seconds of inactivity
Always On permanently
On
Hold Last command is retained
or Activates blackout
blackout,
Full Full On = maximum brightness
Standa- Stand Alone Mode Direct is activated
lone
Linear Light intensity increases linearly with
DMX value
Exponen- Light intensity can be finely adjusted at
tial lower DMX values and broadly adjusted
at higher DMX values
Logarith- Light intensity can be broadly adjusted at
mic lower DMX values and finely adjusted at
higher DMX values
S-curve Light intensity can be finely adjusted at
lower and higher DMX values and broad-
ly adjusted at medium DMX values
17