Jaga BRIZA 22 PLUG & PLAY Anleitung Seite 57

06
1. Insert the screws of the back plate (1-4) and let them stick out 1 cm. [1]
2. Install the back plate. .
3. Tighten the screws. [2]
07
1. Place the screws of the device(5-8) and let them stick out 1 cm. [1]
2. Place the device in the correct position.
3. Tighten the screws. [2]
08
IN
OUT
Connect the device to the hydraulic system by using the specified inlet/ outlet connections. Make sure that the connections are air tight,
use a sealant for this. The coil is equipped with a de-aerater. .
If the unit is used for cooling, the hydraulic pipes must be insulated.
When using devices for cooling: iron couplings prohibited.
JAGA NV | BRIZA 22 - PLUG & PLAY | MANUAL | 2022.03.10 | V.1
IN
OUT
1
1
Use a back-off wrench when faste-
ning the hydronic connections !
Remove black plug at hydraulic
connection.
2
2
EN
57