Troubleshooting - Nilfisk-ALTO GM 100 Sprint Plus Bedienungsanleitung

DJ68-00085W(EN) 10/4/04 12:59 PM
CARING THE Pet Brush turbine (GM 100 Sprint Plus Pet Pack model only)
Open the cover. Push up the
both sides of cover. Lift it
upwards and detach it.
slots
Smart Protector (transparent tube)
(
GM 100 Sprint Plus
GM 100J Sprint Plus
Transparent tube prevent the tube and hose from
being clogged by obstacle like as socks and clothes.
When transparent tube is clogged.
Separate the nozzle from the tube. Remove the alien
substance with a stick from it. After cleaning it,
reassemble the nozzle to the tube.
TROUBLE SHOOTING
PROBLEM
Motor does not start. No power supply.
Suction force is gradually Filter, nozzle or suction
decreasing. hose or tube is blocked.
Check that the cord is not
Cord does not rewind fully.
twisted or wound unevenly.
This Vacuum cleaner is approved the following
Page 8
After cleaning the turbine, reposition it into its' own
place. It cannot be reassembled if the ends of tur-
bine are reversed. If you washing the turbine, it
should be dried thoroughly.
To reattach the cover, align hinges of cover with
slots on the inner sides of nozzle. After aligning,
press the both sides of cover.
)
model only
CAUSE REMEDY
Check cable, plug and
socket.
Remove the object.
Pull the cord out 2~3m &
push down the cord rewind
button.
DJ68-00085P REV ( 0.3 )
EN-7