Spray Technique; Interruption Of Work - WAGNER W 590 FLEXIO Originalbetriebsanleitung

W 590 Flexio
thin paint thin paint
thick paint (e.g. interior wall paint)  thick paint (e.g. interior wall paint)

16. Spray Technique

The spray result depends heavily on the smoothness and cleanliness of the
i
surface to be sprayed. Therefore the surface should be carefully prepared and
kept free of dust.
•
Cover all surfaces not to be sprayed.
•
Cover screw threads or similar parts of the target object.
Important: Start at the edge of the area to be sprayed. Start the spray
i
movement first of all, and then press the trigger. Avoid interruptions
within the area to be sprayed.
•
The spray movement should come from the arm, not just from the wrist. This ensures that
a uniform distance is maintained between the spray gun and the spray surface during
the spray operation. Select a distance of 5 - 15 cm, depending on the desired spray jet
width. When you are using interior wall paint, the distance should be about 20-30 cm
(approx. one stirring rod in length).
Fig. 12 A/ 12 B:
Fig. 12 C:
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray
pattern setting.
•
An even movement of the spray gun results in an even surface quality.
Important: Wipe off the nozzle and air cap regularly
i
to make sure they do not get blocked.
"Cross spray" when using paint with a poor covering capacity or if the
i
surface is highly absorbent (Fig. 13).
•
Interior wall paint in strong colour shades should be applied at least twice (allow first
paint coat to dry first). This will ensure good coverage.

17. Interruption of Work

•
Turn the machine off.
•
Put the machine down only on a level, clean surface. Otherwise the machine could tip
over!

CORRECT Even distance to the object.
INCORRECT An uneven distance will result in uneven paint
application.
Level min to 6 Level min to 6
Level 6 to max Level 6 to max
EN
29