Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Tips for working with the device:
Always hold the device with two hands during operation!
o
Before starting work, clean the wall of protruding nails, screws and electrical installation
o
components, as these can damage the device and be dangerous to the operator.
During work, only a small pressure should be applied so that the entire plate fits evenly on the
o
surface. Excessive pressure can lead to visible traces and unevenness of the surface.
It should be borne in mind that the performance and quality of grinding depends mainly on the
o
correct abrasive and the speed chosen depending on the type of surface to be machined.
Cleaning and maintenance
Before any cleaning and adjustment, replacement of accessories or when the device is not in
o
use, the power plug must be unplugged and the device completely cooled. Wait for the
rotating elements to stop.
To clean the surface, use only agents without corrosive ingredients.
o
Store the device in a dry, cool place, protected from moisture and direct sunlight.
o
It is forbidden to spray the device with a jet of water or to immerse it in water.
o
No water must enter the interior of the device via the ventilation openings on the housing.
o
The ventilation openings must be cleaned with brush and compressed air.
o
With regard to technical efficiency and to prevent damage, the device should be checked
o
regularly.
Use a soft cloth for cleaning.
o
Do not clean the device with acidic substances. Medical devices, thinners, fuel, oils, or other
o
chemicals can damage the device
Environmental protection
Return old equipment unopened to the collection facilities offered for recycling.
Customer Service
See under: https://www.bergtectool.com/dls/
Disposal of used equipment
This product must not be disposed of with normal household waste. Return the equipment to
appropriate collection and recycling centers for electrical and electronic equipment. Check the icon on
the product, instruction manual and packaging. The plastics used in the design of the device can be
recycled according to their marking. By opting for recycling, you make a significant contribution to the
protection of our environment. Contact local authorities for information about your local recycling
facilities.
Guarantee
We provide a guarantee in accordance with the statutory provisions. Proof is provided by invoice
or delivery note. The warranty is only valid in conjunction with a warranty card stamped by the
specialist trade, on which the date of purchase and the device serial number are noted. The data on
the invoice or on the delivery note must match the data on the warranty card.
Werbung
