Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Personal safety
It is not allowed to operate the device in a state of fatigue, illness, under the influence of
o
alcohol, drugs or medication, if this limits the ability to operate the device.
The machine may only be operated by appropriately trained, suitable for operation and
o
physically healthy persons who have read the present instructions and are familiar with the
occupational health and safety requirements.
The machine must not be operated by children or persons with limited physical, sensory and
o
mental abilities or without appropriate experience and knowledge. This is only permitted under
the supervision of a person responsible for safety and after instruction in the operation of the
machine.
Be attentive and use your common sense when running the device. A moment of inattention
o
during work can lead to serious injuries.
Use personal protective equipment that meets the requirements set out in point 1 of the
o
symbol explanations. The use of appropriate and certified protective equipment reduces the
risk of injury.
Before connecting the device to a power source, make sure the switch is off.
o
Don't overestimate your abilities. Ensure a secure stand during work. This gives you better
o
control over the device in case of unexpected situations.
Do not wear wide clothing or jewelry. Keep hair, clothing and gloves away from moving parts.
o
Loose clothing, jewelry or long hair can be captured by moving parts.
If the device has a suction port, check that everything is connected and fastened correctly.
o
Suction can reduce the risk associated with dust.
Remove any setting tools or keys before turning on the device. Items that remain in rotating
o
parts can cause damage and injury.
Safe use of the device
Do not overheat the device. Use only appropriate tools for each application. Properly selected
o
devices and the careful handling of them lead to better work results.
Do not use the device if the ON/OFF switch is not working properly. Devices that cannot be
o
controlled via the switch are dangerous and need to be repaired.
Unplug the device before adjusting accessories, replacing them, or when you are no longer
o
using the device. This reduces the risk of accidental commissioning.
Unused tools should be kept out of the reach of children as well as people who do not know
o
the device or the instructions. In the hands of inexperienced people, these devices can pose a
danger.
Always keep the device in perfect condition. Before each start-up, check whether there is any
o
damage to the device and its moving parts (defective components or other factors that could
affect the safe operation of the machine). In case of damage, the device must be repaired
before use.
Keep the device out of the reach of children.
o
Repair and maintenance of equipment may only be carried out by qualified personnel and with
o
original spare parts. This is the only way to ensure safety during use.
To ensure the functionality of the device, the factory-fitted covers or screws must not be
o
removed.
When transporting between the warehouse and the destination and handling of the device,
o
observe the health and safety principles of the country in which the device is used.
Avoid situations where the device stops while operating under heavy load. This ca n lead to
o
overheating and thus to damage to the device.
Do not touch any moving parts or accessories unless the device has been unplugged.
o
Do not leave this device unattended during operation.
o
The device must be cleaned regularly so that dirt does not settle permanently.
o
The specified vibration emission value was determined using standard measurement
o
methods. It may change if the device is used in different environmental conditions.
Never edit two items at the same time.
o
It is forbidden to intervene in the construction of the device to change its parameters or
o
construction.
Keep devices away from fire and heat sources.
o
Werbung
