Electrical Connections - Saunum LEIL Installations- Und Bedienungsanleitung

ELECTRICAL
CONNECTIONS
The connection of the power unit is shown
on the diagram of electrical connections.
For more information on connecting the
heater, see the heater installation and op-
erating instructions.
RECOMMENDED CABLE DIAMETERS
Temperature sensor-thermal protection (silicon or
other heat resistant material that is able to withstand
a temperature at least 140 °C):
Control panel (a ferrule end-sleeve is required for
stranded cables):
Door sensor:
30
• If the connection and installation
cables are located higher than
1000 mm from the floor of the sau-
na room or inside the walls of the
sauna room, they must be able to
withstand a temperature at least
170 °C (e.g., SSJ). Electrical equip-
ment installed in the steam room
below 1000 mm from the floor must
withstand a temperature of at least
125 °C (e.g., T125).
min 3 x 0.25 mm2
min 4 x 0.34 mm2
min 2 x 0.34 mm2
31