Safety Information - KPS DMM4500PV Benutzerhandbuch

! Safety Information

Understand and follow operating instructions carefully. Use the
meter only as .
WARNING
!
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may
be impaired.
Always use proper terminals, switch position, and range for
measurements.
To reduce the risk of fire or electric shock, do not use this product
around explosive gas or in damp locations.
Verify the Meter operation by measuring a known voltage.
If in doubt, have the Meter serviced.
Do not apply more than the rated voltage, as marked on
Meter, between terminals or between any terminal and earth
ground.
To avoid false readings that can lead to electric shock and injury,
replace the battery as soon as low battery indicator blinks.
Avoid working alone so assistance can be rendered.
Do not use the Tester if the Tester is not operating properly or if it
is wet.
Individual protective device must be used if hazardous live parts
in the installation where the measurement is to be carried out
could be accessible.
Disconnect the test leads from the test points before changing
the position of the function rotary switch.
Never connect a source of voltage when the function rotary
switch is not in voltage position.
When using test leads or probes, keep your fingers behind the
finger guards.
Use caution with voltages above 30 Vac rms, 42 Vac peak, or 60
Vdc. These voltages pose a shock hazard.
Remove test lead from Meter before opening the battery door
or Meter case.
DO NOT USE the test leads when the internal white insulation
layer is exposed.
DO NOT USE the test leads above maximum ratings of CAT.
environment, voltage and current, that are indicated on the
probe and the probe tip guard cap.
DO NOT USE the test leads without the probe tip guard cap in
CAT III and CAT IV environments.
Probe assemblies to be used for MAINS measurements shall
be RATED as appropriate for MEASUREMENT CATEGORY
III or IV according to IEC 61010-031 and shall have a voltage
RATING of at least the voltage of the circuit to be measured.
Only replace the blown fuse with the proper rating as specified
in this manual.
01
EN