Troubleshooting - Yard Force iFlex LM F23 Original Bedienungsanleitung

MAINTENANCE AND STORAGE
Storage and transport
Storage
After cleaning the unit thoroughly, store mower in a dry room and allow the motor to cool
down.
- Move the handle to the storage position. (Fig. M)
- Store the product with the handle detached if required.
NOTE: Remove the battery pack. Ensure cables are not trapped when folding/unfolding the
handle. If stored vertically make sure the mower is positioned in a corner so that the blade is
facing inwards against a wall and the machine is secure to prevent it falling over.
Transport
Use the original packaging to ship whenever possible.
26

TROUBLESHOOTING

WARNING: Before performing any repair work, always ensure that the battery
pack has been removed.
WARNING: Always wear heavy duty gloves when adjusting or cleaning, especially
when handling sharp objects.
Fault/malfunction Cause
Battery is not correctly inserted Remove the battery and reinsert
Mower standing in high grass
The mower housing is clogged
Mower fails to start
Battery has no power
Mower is over loaded
Mower is overheated
Handle position is in the
disactive angle
Cutting height is incorrect
Cutting blade is worn or
damaged
Mower stop working /
loses power
Battery performance
decreasing
Handle position is in the
disactive angle
Cutting blade is loosened
Mower vibrating at
higher speed
Blade is loosened /incorrectly
fitted
The blade is damaged.
Mower cuts unevenly
Blade is assembled incorrectly
Remedy
Start motor on shorter grass or
already mowed area, change cutting
height if necessary
Remove battery pack and clean
housing so that the blade can move
freely
Check and recharge battery
Re-start the mower on shorter grass
Wait until the temperature cools
down
The mower could only started by the
angle between 17°-70°
Adjust the cutting height
Replace with new blade from dealer
service centre
Check the battery performance and
charge it if necessary
The mower could only started by the
angle between 17°-70°
Tighten the blade bolt
Balance the blade by grinding each
cutting edge until equal
Sharpen the blade or replace.
Re-assemble blade correctly
27