Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Yard Force LM C33 Original Bedienungsanleitung

20v akku-rasenmäher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

MAINTENANCE AND STORAGE
Storage and transport
Storage
After cleaning the unit thoroughly, store mower in a dry room and allow the motor to cool
down.
NOTE: Remove the safety key and battery packs. Ensure cables are not trapped when
folding/unfolding the handle. If stored vertically make sure the mower is positioned in a corner
so that the blade is facing inwards against a wall and the machine is secure to prevent it
falling over.
Transport
Use the original packaging to ship whenever possible.
26

TROUBLESHOOTING

WARNING: Before performing any repair work, always ensure that the battery pack
has been removed.
WARNING: Always wear heavy duty gloves when adjusting or cleaning, especially
when handling sharp objects.
Fault/malfunction Cause
Safety key is not inserted
Battery is not correctly inserted Remove the battery and reinsert
Mower standing in high grass
Mower fails to start
The mower housing is clogged
Battery has no power
Cutting height is incorrect
Cutting blade is worn or
Mower stops working
damaged
/loses power
Battery performance
decreasing
Cutting height is too Low
The lawn / grass is wet
Grass bag is not filled
Underside of the mower deck
sufficiently
is clogged.
Cutting blade is worn or dam-
aged.
Cutting blade is unbalanced
Mower vibrating at
higher speed
Blade is Loosened /incorrectly
fitted
The blade is damaged
Mower cuts unevenly
Blade is assembled incorrectly
Remedy
Insert safety key
Start motor on shorter grass or
already mowed area, change cutting
height if necessary
Clean housing so that the blade can
move freely
Check and recharge battery
Adjust the cutting height
Replace with new blade from dealer
service centre
Check the battery performance and
charge it if necessary
Adjust and increase cutting height
Allow the lawn to dry
Clean the underside of the mower
deck
Replace it by contacting the custom-
er service centre
Balance the blade by grinding each
cutting edge until equal
Tighten the blade bolt
Sharpen the blade or replace
Re-assemble blade correctly
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis