Cleaning, Care And Storage - Silvercrest SNOT C1 Originalbetriebsanleitung

To trim hair just above the skin surface, remove
the comb attachment and guide the blade
9 1
directly over the skin in the desired area.
Note: To trim only individual hairs, adjust the
angle of the blade and guide this against
1
the individual hairs.

Cleaning, care and storage

Note: Always switch off the product before cleaning it.
Do not use any corrosive or abrasive cleaning
agents. This might damage the surface of the
product.
Clean the housing with a dry cloth.
Take off the comb attachment (see Fig. C)
9
and clean the blade carefully under the run-
1
ning water (see Fig. D). Then fully dry the blade
before using the product again.
1
Attention: The product is only protected against
from splash water. Never immerse it in the water.
Otherwise, irreparable damage may results.
If there are still hair on the blade , clean it with
1
the double-sided cleaning brush (see Fig. D).
12
To store the product, always put on the protec-
tive cap .
10
Keep the product in a cool, dry location.
38 GB/IE