Technical Data - setma waterGenie Compact Montage- Und Betriebsanleitung

DEsCrIptIon
waterGenie Compact is a ready to install WC
pan with an integrated pump / macerator.
The unit is for domestic use only. Applications
are discharge of a WC and a washbasin. All
other application and commercial use are to
proscribe.
Installed and used correctly, waterGenie
Compact will give consistent and reliable
service.
This device is not designed for persons
(including children) with limited physical,
sensory or mental abilities, or those with
minimal experience and knowledge, unless
they are monitored and are given the
necessary instructions for using the device,
with the help of a person responsible for their
safety. Monitor children and make sure they
do not play with the device.
lIst oF ACCEssorIEs InCluDED
(FIG. 2)
DImEnsIons
(FIG. 3)
pErFormAnCE CurvE
(FIG. 4)

tECHnICAl DAtA

• Max. vertical pumping 3m
• Max. horizontal pumping 30m
• Evacuation diameter 32mm
• Normal power rating 550W
• Medium water temperature 35°C
• Electric class I
uk
InstAllAtIon
a-
Attaching the toilet to the floor (fig. 5a).
Find a suitable location, place the unit on
the floor without attaching it. Mark the
perimeter of the bowl on the floor and
mark where the bracket screws will be,
(rear screwholes). Remove the bowl.
Measure 15mm inwards from the line and
mount the Lbrackets on the floor.
Note: To reduce noise level when the
toilet ist installed on a hard floor, you may
want to insert an insulating material
between the floor and the bowl.
b-
Connection of the discharge (fig. 5b)
c-
Connection of a washbasin (fig.5c).
If you want to connect a washbasin to
your waterGenie Compact unit, please
refer on fig. 1 to 2.
d-
Connection to the water supply.
Connect the water supply hose to a shut
off valve.
Attention: For a correct rinsing, the water
pressure should be at least 1.7 bar.
e- The electrical installation should be carried
by a qualified person.
All wiring must conform to BS7671, 1992
requirements for electrical installation. The
unit requires a 220/240 V single phase AC
50 Hz supply (UK specification). Do not
connect the unit to a conventional plug
and socket. The unit should be connected
to a fully earthed electrical supply (class 1).
It must be wired into an unswitched fused
fixed wiring connector protected by a 5
amp fuse and a residual current detector
(30 mA). This connection must be used
exclusively for supplying the unit.
SETMA (Deutschland) GmbH
Siemensstrasse 3
D-85716 Unterschleissheim
Tél. +49 (0)89 / 317 13 19 - Fax +49(0)89 / 317 57 66