MaxxHome 20501 Bedienungsanleitung Seite 32

seasonal use:
Nozzle
Carefully unscrew nozzle from nozzle fitting. Blow compressed air through nozzle orifice to free it from
dirt. Replace nozzle if necessary.
Air Filters
Clean air filters. Remove filter end cover (11), wash air intake filter (10) using a light detergent and dry
Air Filters
it thoroughly before re-installing. Replace air delivery filter (9) once a year (Fig.3)
Clean air filters. Remove filter end cover (11), wash air intake filter (10) using a light detergent
and dry it thoroughly before re-installing. Replace air delivery filter (9) once a year (Fig. 3)
Electrical
Electrical
Inspect cables, electrical parts and connections.
Inspect cables, electrical parts and connections.
8. Wiring Diagram
8. Wiring Diagram
Fig. 3
Ignition Electrodes
Clean, adjust and if necessary replace ignition electrode. For electrode gaps see Fig. 4-5
(dimensions in mm).
Ignition Electrodes
Clean, adjust and if necessary replace ignition electrode. For electrode gaps see Fig. 4-5 (dimensions
in mm).
Fig.4
Compressor Pressure Adjustment (Fig. 6)
Fig. 4
The compressor pressure is factory set and must be checked and adjusted by qualified
Compressor Pressure Adjustment (Fig. 6)
technicians only. Tampering with the unit may be dangerous.
▲ The compressor pressure is factory set and must be checked and adjusted by qualified
technicians only. Tampering with the unit may be dangerous.
Remove pressure gauge cap. Connect a pressure gauge on the pressure measuring port on the rear
Remove pressure gauge cap. Connect a pressure gauge on the pressure measuring port on the
guard. Start heater and read air pressure value. If necessary adjust pressure to the correct value
rear guard. Start heater and read air pressure value. If necessary adjust pressure to the correct
turning the adjusting screw (the air vent hole in the adjusting screw middle) clockwise to increase,
value turning the adjusting screw (the air vent hole in the adjusting screw middle) clockwise to
anticlockwise to decrease the pressure:
increase, anticlockwise to decrease the pressure:
Electrical
Electrical
Inspect cables, electrical parts and connections.
Inspect cables, electrical parts and connections.
8. Wiring Diagram
32
Model
Model
BGO1601-20
BGO1601-20
BGO1601-30
BGO1601-30
BGO1601-50
BGO1601-50
Fig.6
Fig.6
Fig.3
Fig. 5
Model
20501
20553
20503
Fig.6
Fig. 6
Air Pressure (bar)
Air Pressure (bar)
0.32
0.31
0.45
Fig.5
Air Pressure (bar)
Model Air Pressure (bar)
0.32
BGO1601-20
BGO1601-30
0.31
BGO1601-50
0.45
0.32
0.31
0.45
0.32
0.31
0.45