Electric Installation - CARAVITA BIG BEN 2 Bedienungsanleitung

DESCRIPTION OF THE LIGHTS AND THE ELECTRICAL PARTS
The Elegance lighting system consists of LED-strips embeded in an aluminium case with diffusor. It is attached to the supporting struts.
of the sunshade. The wires are integrated in the mast. The LED-density is 120 (RGB: 60) per meter.
The electrical box is located below the lower hub. The power supply from the ground is lead through the struts to the lights. The elec-
trical box is sealed. The switch for the lights and/or heaters is located on the lower side of the box.
Big Ben with integrated light is connected with 230V/50Hz and 16A fuse as power supply!
Big Ben with integrated light and wires for Solamagic heaters is connected with 400V/50Hz and 16A fuse as power supply!
The user of the umbrella has to make sure that the power supply is protected from being damaged.
Please connect the umbrella only with the connection cable delivered. Otherwise ask a qualifi ed company / speciality retailer
for indivudual connection solutions.
Loosen the screws and remove the protec-
tive cover. The socket is located below.
Put the other end of the cable with the
Schuko plug into the socket. Watch out
for appropriate connection with 230V or
400V.
The connection cable must be put in a way making it impossible to be damaged or stumbled across.
Big Ben 2017 Page / Seite / Page / Página 5
Important:

ELECTRIC INSTALLATION

Put the plug into the socket and secure it
with the clamp.
Lights are switched on and off by pushing
the switch below the lower hub.
WARNING:
Tighten the protective cover with the
screws.
Using the remote control is an alternative.