Herunterladen Inhalt Inhalt Diese Seite drucken

CARAVITA BIG BEN 2 Bedienungsanleitung Seite 4

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Prepare your mobile stand or ground anchor as instructed by their corresponding manual
and have the required accessory hardware ready for install. All sheet stands that use pavers
should have the appropriate pavers installed and fi llable stands should be fi lled with appro-
priate weighted material.
Remove the protection bag before installing if you do not have a push-rod which enables you
to remove the protection bag from a set up umbrella.
Install the supplied cover cap and fi nial at the top of the umbrella.
Before setting up the umbrella, make sure the area is clear of people and objects underneath that could be harmed or damaged and/
or could cause damage to the umbrella.
Please be aware, that the umbrella is very tall, and thus hard to balance in an upright position. For this reason hold the umbrella fi rmly
when installing to reduce the risk of injury.
1) Put one of the 5 fl ange screws (M10x25) into the central hole.
Let the screw protude about 10mm.
2) Carfully put the umbrella on the fl oor, with the lower end
pointing towards the ground sleeve.
3) Using the alignment guide on the base of the umbrella, positi-
on on the central screw, and raise the umbrella with both hands
into an upright position.
CAUTION! - DO NOT LET GO OF THE UMBRELLA!
IT CAN STILL FALL OVER!
Big Ben 2017 Page / Seite / Page / Página 4
SETTING UP THE UMBRELLA
4) Hold the umbrella upright while a second person screws it to
the base with the 4 screws (M10x35) and the washers provided.
Do not tighten the screws yet.
5) Adjust the orientation of the umbrella. Then tighten the screws.
At times when the umbrella is not installed on the ground
sleeve, close the holes of the ground sleeve against dirt with the
provided fl ange screws (M10x25).
The purpose of the plastic mesh attached to the struts is to pro-
vide protection to the shade against damage during transport.
Once the umbrella is open, the mesh can be removed carefully
with scissors or a knife. Be careful not to damage the shade!
For safety-purposes, two people
should set up the umbrella.
Very large umbrellas weigh up to
100kg. Work carefully and foresight-
ful to avoid danger.
At least three persons should work
on very large umbrellas!

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis