Balluff BOS 18E-PI-RD30-S4 Bedienungsanleitung Seite 11

Photoelectric Sensors
Red light diffuse reflective energetic BOS 18E-PI-RD30-S4 with IO-Link
Safety Notes
These photoelectric sensors may not be used in
applications where personal safety depends on
proper function of the devices (not safety
designed per EU machine guideline). Read
these operating instructions carefully before
putting the device into service.
Exempt Group according to EN 62471:2008.
DO NOT STARE INTO THE LIGHT BEAM!
Danger of glare and irritation!
The sensor must be installed so that no direct
looking into the light source is possible even
during operation.
The CE Marking confirms that our products
conform to the EC Directives 2004/108/EEC
(EMC) and the EMC Law.
In our EMC Laboratory, which is accredited by
the DATech for Testing of Electromagnetic
Compatibility, proof has been documented that
these Balluff products meet the EMC require-
ments of the harmonized standard EN 60947-5-2.
1 english
Order code Diffuse reflective energetic with IO-Link
BOS023E BOS 18E-PI-RD30-S4
– Convenient setting via IO-Link
– Extremely rugged housing with the highest resistance to aggressive cleaning agents
(ECOLAB conformal), disinfectants (e.g. H2O2) and other chemicals.
– Highly visible light spot for ease of alignment
– Comprehensive parameter setting options
PNP
Installation
Attention!
Do not stare into the light beam.
Fig. 1: Dimensions
Wiring diagramms
Fig. 2: Connection diagram, pinouts
Sensor replacement
Sensor replacement may require a re-parameterization of
the switching points.
NO/NC (selectable)