Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Care & Maintenance
EN
Cleaning the Cyclone Assembly
1. Rotate the cyclone assembly in the direction as illustrated to unlock it, then
remove the cyclone assembly.
Note: Use the 2-in-1 crevice nozzle to remove cyclone separator from the housing.
Turn the nozzle in the direction as shown in the diagram for a thorough cleaning.
2
1
2. Rinse the cyclone assembly with water until it is clean. Thoroughly dry the cyclone
assembly.
Note: Keep it in a ventilated or cool place for at least 24 hours.
16
3
12
11
1
10
2
24 hrs
9
3
8
4
7
5
6
Care & Maintenance
Cleaning the HEPA Filter Assembly
1. Place the vacuum securely on a flat surface, then turn the HEPA filter assembly
cover in the direction indicated and remove the HEPA filter assembly.
Note: Remove the built-in foam pad before cleaning the HEPA filter assembly.
2
2. Rinse the HEPA filter and foam pad with water. To thoroughly remove all the dust
caught in the filter, rotate the HEPA filter by 360 degrees while rinsing. Lightly tap the
filter against a sink several times to remove any excess debris. Keep the HEPA filter in
a well-ventilated and cool place to fully dry.
Note: Fully dry the filter (at least 24 hours) before reinstalling it.
EN
1
3
12
11
1
10
2
24 hrs
9
3
8
4
7
5
6
17
Werbung
Inhaltsverzeichnis
