Start-Up; Attach Front Panel; Detach Front Panel; Operation - AEG AR 4020 Bedienungsanleitung

ENGLISH
68

Start-up

To protect against theft remove the front panel. Do not
keep the front panel in the car.
NOTE
►
Keep the front panel in its casing.
►
Do not touch the contacts on the unit or on the
front panel.

Attach Front Panel

Set the control panel with the left-hand side first into
‹
the frame.
Then push the right-hand side in until it clicks into
‹
place.
Flip the control panel up until it clicks into place.
‹
Ensure the front panel is attached properly. If the front
‹
panel is not attached properly this can cause malfunc-
tions.

Detach Front Panel

Press the release button (1) and flip the control panel
‹
down.
Then pull gently on the right-hand side of the control
‹
panel to detach the control panel.

Operation

This chapter gives important operating instructions for
the unit.

On/Off

/MUTE (11) to switch on the set. The
Press the button
‹
display is activated.
Hold down the /MUTE (11) button to switch the unit
‹
off.

Settings

Volume
WARNING
Hearing damage due to high volume!
High volumes can permanently damage your hearing.
►
Set a moderate volume.
Turn the multi control knob (21) to set the volume.
‹
Switch unit to mute
Press the /MUTE (11) button to switch the unit to
‹
mute. The MUTE indicator appears on the display.
/MUTE (11) button again to deactivate the
Press the
‹
function.
Sound Settings
Press the multi control knob (21).The current volume is
‹
displayed. Press again to cycle through the next setting
options.
The following settings are possible:
VOL - volume (0 to 100)
BAS - bass (-10 to +10)
TRB - treble (-10 to +10)
BAL - Balance (sound distribution between left and
right speakers) (10L to 10R)
FAD - Fader (sound distribution between rear and front
speakers) (10F to 10R)
Turn the multi control knob to change the displayed
‹
setting.