Faber e-SliM Linear Fire Bedienungsanleitung Seite 30

Flame effect does not turn on
In some cases, the display an
error code followed by an X to
indicate which sump(s) regis-
tered the error .
For example, where there are
three flame modules and the
middle one is affected, the
display will flash the error
code, followed by _X_ .
Flame Connect App-related
error
CD44 Extractor fan(s) error
CD45 Incorrect number of
modules detected .
CD51 Low water level in one
of the sumps .
CD56 The timing for filling the
sump has been maxed
out .
CD57 Possible leak in the
unit .
CD58 Overflow has been de-
tected .
CD53 Fireplace settings are
out of sync with the
app .
30
See service manual .
See service manual .
Restart the unit by turning
the power off from the power
switch or breaker for 10 sec-
onds before turning it back on .
Check plumbing connections .
If error persists, see service
manual .
Restart the unit by turning
the power off from the power
switch or breaker for 10 sec-
onds before turning it back on .
Check water pressure and
plumbing connections .
If error persists, see service
manual .
Restart the unit by turning
the power off from the power
switch or breaker for 10 sec-
onds before turning it back on .
Check water pressure and
plumbing connections .
If error persists, see service
manual .
Inspect the modules and care-
fully remove excess water .
See service manual .
Open the app on your mobile
device to synchronize settings .