Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
By using Scraper
1) Use the Cleaning Pin to remove scale deposits from the small
hole of the steam outlet in the Main Body, as illustrated in Fig. 2.
By swirling and pushing the pin up and down you will clean the
steam outlet. Always ensure that all scale debris have been
removed from the steam outlet before reassembling. Continue
swirling Cleaning Pin until no further debris is evident.
By using cleaning solution
1) Prepare a solution of 1/3 white vinegar and 2/3 tap water and add to the water tank.
2) Secure and position the unit to ensure steam released is aimed away from the floor or
surrounding objects and surfaces. Plug the unit in, turn the unit ON by pressing the Power
Switch ( O / I ) and allow the unit to produce steam until the vinegar/water solution is used
up.
3) Repeat the above procedure as many times as necessary until a normal steam flow rate
is achieved.
4) Fill the Water Tank with fresh water and rinse out.
5) Fill the Water Tank with fresh water, attach to the unit and release steam through the
system until the Water Tank is empty.
WARNING
Do not leave the steamer unattended during the lime scale removal process and/or
while in use.
NOTICE
Perform a test cleaning on a suitable isolated area after each lime scale removal to ensure
that there is no debris left in the system.
WARNING
DANGER OF SCALDING
Cleaning blocked steamer accessories.
Due to the high mineral content of water in some areas, you may notice that less steam
comes out from the Hand-Held Steamer accessories.
This may be caused by calcium buildup inside the tip of the nozzle.
How to clean calcium buildup:
We recommend using a spray lubricant. Spray a small burst or two of the lubricant inside
the tip of the Jet Nozzle. After spraying lubricant inside the component, fill the steamer with
water according to the directions and run a continuous jet of steam through the affected
accessory for several minutes to remove the deposit. Once the steam pathway is clear,
aim the steamer at a neutral surface or a cleaning cloth to make sure no debris is emitted.
WE RECOMMEND PREFORMING THIS PROCEDURE IN A PROTECTED AND WELL-
VENTILATED AREA.
Microfiber Cloth care:
• Machine wash at 60 ºC (140 ºF)
• Do not bleach
• Do not use fabric softener
34/53
Werbung
Inhaltsverzeichnis
