MALTEC SteamExpert HDS4500W Bedienungsanleitung Seite 24

4) Place the Mircofiber Cloth on the bottom of the Mop
Head and make sure all the loops on the cloth are
aligned with gripping hooks on the bottom of the Mop
Head (Refer to Fig. 5a), then press the cloth against the
Mop head so the loops on the cloth catch the gripping
strips on the Mop Head and hold the pieces together.
5) When using the STEAM MOP on carpet surfaces: Place
the Mop Head, with Microfiber Cloth in place, on top of the
carpet glider as illustrated in Fig. 6a. Do not attempt to use
the STEAM MOP unit on carpet/rug surfaces without the
carpet glider in place.
NOTICE
Never use the carpet glider on surfaces that are prone
to scratching.
CAUTION
Never assemble or remove the accessories while the unit is in operation.
HOW TO USE THE STEAM MOP
PLEASE READ BEFORE USE
The STEAM MOP is designed to thoroughly clean floor surfaces, such as marble, ceramic,
carpet, stone, linoleum, and sealed hardwood floors and parquet. Not all floor types are
suitable for steam cleaning.
The heat and steam action my remove the wax on surfaces treated with wax. Do not use
on unsealed flooring or let unit stand on any wood or heat sensitive floor for an extended
period of time. This could cause the wood grain to rise, in addition to other types of
damage.
When using on vinyl, linoleum or any other heat sensitive floors, use extra caution. Too
much heat can melt glue in the flooring. Use only on laminated flooring that has been laid
professionally and without any gaps or cracks that would permit the entry of moisture. Test
the STEAM MOP on a small isolated area of your flooring prior to overall use on any floor
surface. Always check the use and care instructions of your flooring manufacturer or
distributor before using the STEAM MOP.
When in doubt, please consult a flooring specialist. Only use the carpet glider on carpeting
and rugs. Use of the carpet glider on other floor surfaces will cause streaking and possibly
scratching.
NOTICE
This product emits steam and creates moisture. Water marks, discoloration or
damage to the floor surface can occur if the unit is left operating too long in one
place.
24/53