MALTEC SteamExpert HDS4500W Bedienungsanleitung Seite 26

When the Ready-to-Use indicator light turns Green Turn the Power Switch (O / I) to the
ON (I) position. The mop will start emitting steam.
To stop emitting steam turn OFF (O) the unit by turning the Power Switch (O / I) again.
If the Power Switch (O / I) is turned prior to Ready-to-Use light indicator turning green,
water from the previous use will not be heated and will be forced out by present steam and
will cause puddling to occur.
This may also happen if the Power Switch was left in the ON (I) position from the previous
use and the unit was disconnected by unplugging only. Make sure to turn the unit OFF
after each usage and then disconnect from the electrical outlet so the unit is in the OFF
(O) position when used next time.
3） Select one of the following Steam Regulator positions:
1 – Low, 2 – Medium, 3 – High and 4 – Hot Spray
• 1 – Low and
• 2 – Medium Setting: Ideal for cleaning all hard floors, such as
linoleum, ceramic, marble, wood, etc.
• 3 – High Setting: Ideal for cleaning carpets and rugs.
• 4 – Hot Spray Setting: Ideal for cleaning bathrooms, kitchens,
window sills, car wheels, etc.
You can change the Steam Regulator position and change the
steam output while operating the STEAM MOP
4) Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the dirt
loosened by the steam. Apply steam liberally. Keep a towel handy and wipe away any
excess water that may accumulate.
5) When the STEAM MOP stops emitting steam, simply turn OFF and unplug the
appliance, refill the Water Tank and continue cleaning.
WARNING
Never leave the STEAM MOP unattended while plugged in.
For Best Results:
1) Sweep or vacuum floor prior to using the STEAM MOP.
2) To avoid puddling of water, the Microfiber Cloth must be clean
and dry for use. To replace the cleaning cloth, proceed as follows:
Let the cleaning cloth cool down, remove cloth from unit, replace
with a new Microfiber Cloth (Optional Item) and continue use. Select
low steam regulator position.
3) To sanitize an area of your floor, leave the STEAM MOP at high
steam setting over the steam area for about 10 seconds, but no
longer than 15 seconds.
NOTICE
Do not carry out this procedure on heat and steam sensitive
floors.
26/53