Operating The Appliance - Arzum GLASSY AR 360 Gebrauchsanweisung

• Protect your hand from steam which emerges while water is boiling, and do not
allow children to use your appliance.
• While there is no water in the water heater or it is not used, light of power
button should be off position AbSOLUTELY.
• If your appliance is left in operating state by mistake while it is empty or
there is not enough water inside it, safe shut-off assembly will turn off power
automatically. In such a case, wait for your appliance to cool down completely
before refilling it with water.
• Pay attention that water which you fill into water heater tank should not exceed
maximum water level.
WARNING: You can boil only water in the water heater tank. NEvER use any
other liquid or solution.
• NEvER immerse water heater tank of your appliance into water or any liquid, do
not wash it in the dishwashing machine, and do not use it in the bathroom or in any
similar locations with high humidity rate.
• Pay attention not to wet cable and electrical terminals of your appliance and never
leave wet. If it gets wet, never operate your appliance by plugging before drying it.
• Use your appliance as recommended and for its intended purpose.
• Instructions for normal cleaning of appliances after use and not immersing in
water for cleaning mean that the appliance should not be immersed in water.
• Use your appliance as recommended and for its intended purpose.
• If power cable is damaged, it should be replaced by the manufacturer, service
agent or similar qualified staff in order to avoid the danger.
WARNING: NEvER operate your appliance while there is no water in the
water heater tank or water level is under 0,5 lt.
GLASSY
USING THE KETTLE
• Arzum Glassy Glass Kettle with Concealed Resistance gets warm during the
usage, therefore do not touch glass surface of the appliance. When the water starts
to boil within the appliance, keep your hand away from the nozzle of appliance.
• When you request to take your appliance from the energy transmission base, the
appliance should have been turned off automatically or you should turn off it.
• You can boil only water with your kettle. Never use another liquid or solution.
• Wash your kettle before first usage, and then, fill water up to MAX water level.
Boil water until your appliance turns off automatically.
14
• Pour this water and leave your to cool down.
• While this operation is made, pay attention that
water should be in the maximum level.
• After the water is boiled, it is normal to form
powdery residue in boiled water according to the
hardness degree of the water. This condition is caused
by water and it does not have any harm to human
health.
• While on / off switch of your appliance is on (I), the
lid of your kettle should be in the closed position CERTAINLY.
FILLING THE WATER:
• While filling the water, ALWAYS remove your
appliance from its energy transmission base. You can
prevent spilling water into the tray in this way.
• Always fill the water between the levels of min. (0,5
lt) or max. (1,7 lt) into your kettle.
If you try to boil water below the minimum level,
it can cause early closure of the appliance, if you try
to boil water above the maximum level, it can cause
overflowing the water.

OPERATING THE APPLIANCE

• Open the network cable wrapped under the energy transmission base of Arzum
Glassy Glass Kettle with Concealed Resistance completely and connect it to
grounding plug.
• Fill the water between the limits of maximum (1,7 lt) and minimum (0,5 lt) into
your kettle according to quantity of water that you want, and close the lid.
• Place your kettle on the energy transmission base.
• Open it by turning
the on/off switch to "I"
position. Led warning
lamp will light and water
will start to get warm,
when the water boils, on
/ off switch will turn off
automatically, Led light will
turn off and will switch to
the off position.
• If you wish, you can bring the on/off switch to off "0" position in order to stop the
boiling function.
15