Kinderkraft MOOV Bedienungsanleitung Seite 32

WARNING! The seat must be always placed on the frame back
to the direction of travel (the child should face the person
pushing the buggy).
VIII USE OF BRAKE The buggy is equipped with a foot brake located on the rear axle. Press the brake pedal down to
activate it. The brake is released after the pedal is lifted up (FIG. 29).
IX BUGGY DISASSEMBLY After removing the bassinet/seat or child safety seat (FIG. 28 & 39), press the frame collapse
lock, and then pull the levers at both sides and finish with pushing down the parent handle (FIG. 30). A correctly folded
frame must be secured with the side lock (FIG. 31). If necessary, the front and rear wheels can be removed from the
frame by pressing the buttons marked in Figures 32 and 33.
X BUGGY ADJUSTMENT Front wheels in the MOOV buggy can be blocked in the forward movement position. Enable this
mode by lowering the lock sliders (FIG. 34). To unlock the front wheels, pull the sliders up.
The hood can be enlarged by opening the zip fastener on the outer side of the cover (FIG. 35).
To adjust the parent handle, press the lock buttons on both sides of the buggy and adjust the handle to a comfortable
height (FIG. 36).
The safety bar can be detached from the frame partially or completely by pressing a button on the side/sides (FIG. 37)
The seat tilt angle can be adjusted using the lever at the top (FIG. 38). The seat has three positions: lying, reclining and
sitting.
WARNING! When the seat is in the reclining position, do not unfasten
the straps at the back of the backrest, as this may cause the child's
head to be positioned lower than the rest of their body.
The seat is adjustable so that the child can face the parent or the direction of travel. To do this, press the buttons on
both sides of the seat, change the direction and attach the seat until it clicks (FIG. 39).
XI RESTRAINT SYSTEM. To secure the child, connect the fasteners of hip and shoulder belts and then insert them into the
middle clamp (FIG. 40) until it engages. Adjust restraint system each time you fasten, to properly secure the child.
The belts are unfastened in the reverse order.
The mattress (H) supplied should be always placed in the bassinet/seat. For the smallest children who are not yet able to
sit unaided, the restraint system in the bassinet should be threaded through the slots in the mattress and hidden under
it. The seat/carrycot has attachment points for an additional harness.
XII CARE AND MAINTENANCE The buyer is responsible for proper installation of all functional elements as well as for
carrying out all required maintenance and adjustments in order to keep the buggy in good technical condition.
The buggy must be periodically checked for potential problems. Significant measures to be applied to ensure the child's
safety and prevent shortening of the product life have been presented below:
• Check the strength and safety of all rivets and connections.
• Check all wheel locking equipment and tyres. If necessary, replace or repair.
• Check if all safety devices work properly, particularly the main and additional fasteners that should move freely at any
time.
Please, stop using the buggy if there are doubts as to its proper use or a suspicion of any danger.
If the wheels squeak, apply a thin layer of silicone. Do not use oil or grease based products as they attract dirt, which
makes buggy movement difficult.
XIII CLEANING If the elements of the buggy chassis have been exposed to saltwater, rinse with tap water as soon as
possible.
Do not wash. Clean the product gently
with a damp cloth and a mild detergent
Do not bleach
Do not iron
Hand wash
Hood, basket: Do not wash. Clean the product gently with a damp cloth and a mild detergent. Do not bleach. Do not dry
in a tumble dryer. Do not iron. Do not dry clean
Wash at max. 30°C, gentle process
Do not dry in a tumble dryer
Do not dry clean
32