Herunterladen Inhalt Inhalt Diese Seite drucken

aidapt Bewl VB505 Aufbau- Und Wartungs-Anleitung Seite 5

Dusch- und toilettenstuhl mit selbstantrieb
Vorschau ausblenden Andere Handbücher für Bewl VB505:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

COMMODE BUCKET
To remove the commode bucket, simply slide the bucket out from the chrome runners at the
rear of the commode. Cover the top of the bucket to avoid splashing, carefully dispose of the
contents into a proper sluice or WC. Never use an open drain, sink or basin. This could cause
a serious health risk. To avoid the possibility of trapping, do not slide the commode pan on
or off the rails while somebody is sitting on the chair.
Clean out the residue with a suitable disinfectant and refit to the commode after use
NB. Always remove the commode bucket prior to removing the grey horseshoe seat.
CLEANING
A useful guide to decontamination is MHRA leaflet DB2003(06).
Do not use abrasive cleaners as this could damage the surface of the equipment. For
cleaning, wipe with a clean cloth soaked in detergent solution and wring out. Depending on
the detergent manufacturer's instructions the solution may be heated.
Wipe all surfaces of the equipment and the cloth should be re-immersed periodically and the
detergent changed frequently. The detergent should be rinsed or wiped off using a clean
cloth immersed in clean water and wrung out.
To disinfect make sure the equipment has been cleaned and dried and then wipe over with a
clean cloth and a compatible liquid disinfectant. After disinfecting clean with clean water
and dry.
When using detergent or disinfectants then please refer to manufacturers' instructions and if
unsure then consult your local Infection Control Specialist for advice.
This product is not suitable for cleaning with moist heat or autoclaving.
APERTURE COVER
When transferring to and from the Bewl Shower Chair, be careful not to apply weight to the
grey removable toileting aperture cover. This may cause the padded aperture cover to push
through.
NB. The padded aperture cover is not designed to be load bearing.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all components
for their safety, also check all upholstery for security, splits, etc. If in any doubt, please do not
issue or use, but immediately contact your supplier for service support.
When reissuing, a risk assessment may be required as to the suitability of the chair for a
particular user.
MAINTENANCE
Please make a safety check of the product at regular intervals or if you have any concerns,
paying particular attention to the castors.
Assembly and Operating Instructions
Ver. 5 08/2014 (2011)
5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis