Active AGi3500 Benutzerhandbuch Seite 51

3. CONTROL FUNCTION:
Overload indicator light (RED).
The overload indicator light comes on when
an overload of a connected electrical device
is detected, the inverter control unit overheats,
or the AC output voltage rises. Then, the AC
protector will trip, stopping power generation
in order to protect the generator and any
connected electric devices. The AC pilot light
(Green) will go off and the overload indicator
light (Red) will stay on, but the engine will not
stop running.
When the overload indicator light
comes on and power generation
stops, proceed as follows:
1. Turn off any connected electric
devices and stop the engine.
2. Reduce the total wattage of
connected electric devices within the
rated output.
3. Check for blockages in the cooling
air Inlet and around the control unit. If
any blockages are found remove.
4. After checking, restart the engine.
TIP:
The overload indicator light may come on
for a few seconds at first when using
electric devices that require a large
starting current, such as a compressor or
a submergible pump. However, this is not
a malfunction.
AC pilot light (GREEN).
The AC pilot light comes on when the engine
starts and produces power.
51