Active AGi3500 Benutzerhandbuch Seite 50

3. CONTROL FUNCTION:
Multimeter
Liquid crystal display
Operating key
Oil warning light
Overload indicator light
AC pilot light
50
Digital display meter.
Liquid crystal display
Normal operation:
During the normal operation, the
operation key ③ for switching the display and
recycling showing: voltage- current-power-
accumulative time-current time.
In case of failed operation:
U> a: AC over voltage, indicating the character
of AC (alternative indication of AC
and digit).
b: DC over voltage, indicating the character
of DC (alternative indication of DC
and digit).
U< a: AC under-voltage, indicating the
character of AC (alternative indication
of AC and digit).
b: DC under-voltage, indicating the
character of DC (alternative indication
of DC and digit).
I> Output over current of generator.
Output short circuit of generator.
Over heat of generator.
Maintenance time.
Oil warning light.
When the oil level falls below the lower level,
the oil warning light comes on and then the
engine stops automatically. Unless you refill
with oil, the engine will not start again.
Tip: If the engine stalls or does not start, turn
the engine switch to "ON" and then pull
the recoil starter. If the oil warning light
flickers for a few seconds, the engine oil is
insufficient. Add oil and restart.