Victron energy SmartSolar MPPT 75/10 Anleitung Seite 15

SmartSolar charge controller
Battery voltage
Maximum battery current
Nominal PV power, 48V 1a,b)
Max. PV short circuit current 2)
Automatic load disconnect
Maximum PV open circuit voltage
Peak efficiency
Self consumption
Charge voltage 'absorption'
Charge voltage 'equalization'
Charge voltage 'float'
Charge algorithm
Temperature compensation
Continuous load current, 12/24V
Continuous load current, 36/48V
Low voltage load disconnect
Low voltage load reconnect
Protection
Operating temperature
Humidity
Maximum altitude
Environmental condition
Pollution degree
Data communication port
Colour
Power terminals
Protection category
Weight
Dimensions (h x w x d)
Safety
1a) If more PV power is connected, the controller will limit input power
1b) The PV voltage must exceed Vbat + 5V for the controller to start.
Thereafter the minimum PV voltage is Vbat + 1V.
2) A higher short circuit current may damage the controller in case of reverse polarity connection of the PV
array.
MPPT 100/20-48V
12/24/48V Auto Select
1160W (290W / 580W / 870W)
Yes, maximum load 20A(12/24V) & 0,1A(36/48V)
14,4V / 28,8V / 43,2V / 57,6V
16,2V / 32,4V / 48,6V / 64,8V
13,8V / 27,6V / 41,4V / 55,2V
multi-stage adaptive
-16mV/ °C / -32mV/ °C / -48mV/ °C / -64mV/ °C
11,1 / 22,2 / 33,3 / 44,4V or 11,8 / 23,6 / 35,4 / 47,2V
or BatteryLife algorithm
13,1 / 26,2 / 39,3 / 52,4V or 14 / 28 / 42 / 56V
or BatteryLife algorithm
Output short circuit / Over temperature
-30 to +60°C (full rated output up to 40°C)
100%, non-condensing
5000m (full rated output up to 2000m)
Indoor type 1, unconditioned
VE.Direct
See the data communication white paper on our website
ENCLOSURE
Blue (RAL 5012)
6mm² / AWG10
IP43 (electronic components)
IP22 (connection area)
100 x 113 x 60 mm
STANDARDS
EN/IEC 62109-1, UL 1741, CSA C22.2
20A
20A
100V
98%
15mA
(adjustable)
(adjustable)
(adjustable)
20A
1A
PD3
0,65 kg
13