Husqvarna WDC 220 Bedienungsanweisung Seite 10

Products with the Dust
•
Class L, has a tested
filter material. The maximum
degree of permeability is
1%. There is no special
requirement for disposal.
Note:
Refer to local laws. They can regulate the age
of the operator.
Safety for double-insulated products
WARNING:
given in this manual and only with the
manufacturer's recommended accessories.
WARNING:
Read these important instructions.These
instructions have been prepared with safety
and efficiency paramount. The operator
must be trained by an approved instructor
and must understand these instructions for
operation. The operator must know all the
related regulations and legislation in force at
the time of operation.
WARNING:
product: Make sure that the mains voltage
and the mains frequency of the power
supply match the data on the rating plate of
the wet/dry vacuum cleaner.
WARNING:
insulation. Use only Husqvarna replacement
parts. See instructions on how to do service
on double-insulated products.
WARNING:
cord. If the cord is damaged, it must be
replaced by a cord of the same type. This
is available at approved service centers and
dealers and must be installed by approved
personnel.
WARNING:
insulated product requires knowledge of the
system. In a double-insulated products, two
systems of insulation are provided instead of
grounding. No grounding means is provided
on a double-insulated product, nor should
a mean for grounding be added to the
appliance. Service must be done only by
10
Only use the product as
Only applicable to UK:
Before you connect the
This product has double
The product has a special
Service on a double-
approved service personnel. Replacement
parts for a double-insulated product must
be identical to the parts they replace.
A double- insulated product is marked
with the words "DOUBLE INSULATION" or
"DOUBLE INSULATED." A symbol may also
be used on the product.
Electrical safety
• It is recommended that the vacuum-cleaner should
be connected via a residual current circuit breaker.
• Arrange the electrical parts (sockets, plugs and
couplings) and lay down the extension lead so that
the protection class is maintained.
• Connectors and couplings of power supply cords
and extension leads must be watertight.
Extension lead
• As an extension lead, only use the version specified
by the manufacturer or one of a higher quality.
• When using an extension lead, check the minimum
cross-sections of the cable:
Cable length Cross section
< 16 A
< 20 m 1.5 mm
20-50 m 2.5 mm
WARNING:
section of the vacuum-
cleaner contains live
components. Contact with
live components leads
to serious or even fatal
injuries.
Never spray water on to the
•
upper section of the vacuum-
cleaner.
WARNING:
due to faulty
mains connecting lead.
Touching a faulty mains
connecting lead can
< 25 A
2 2
2.5 mm
2 2
4.0 mm
The upper
Electric shock
562 - 005 -