eichhorn Designer 2-in-1 Gebrauchsanleitung Seite 25

Adjusting the excenter:
The pressure with which the excenter is holding the hood can
be adjusted on a nut inside the hood (picture 24).
NOTE: Adjusting the hood is always easiest done
with both hands simultanious.
The harness system should be adjusted to the size of the child and always applied. As the
harness system needs to be removed for washing it needs to be replaced prior using the
product again:
To install the harness system please push the anchors through
the slits in the seat-unit (with the small side ahead): 2x on the
backrest, above the shoulders - and one between the legs.
(picture 25)
Please give the harness anchors a short pull to ensure yourself
they are installed correctly.
At the sides of the stroller seat there are 2x holes - through
these please attach the snap-hooks in the according D-rings
(picture 26).
Warning PLEASE MAKE SURE THE HARNESS
SYSTEM IS FULLY ATTCHED BEFORE
USING THE STROLLER.
Warning CHECK
EVERY USE OF THE STROLLER.
5-point-harness system
THE HARNESS
- 25 -
BEFORE