eichhorn Designer 2-in-1 Gebrauchsanleitung Seite 21

Wheels:
To attach the wheels, put onto axle, push down (Picture
14/A) and hold metal half circle loop located in the centre of
the wheel click into position.
Give the wheel a pull to make sure its locked into place.
(Picture 14/B)
The wheels run on ball bearings - do not grease or oil the
axles - the plastic hub should just sit in the axle - the wheel
should turn on this hub.
The grease on the axle has been put only out of the purpose
the wheels go on better when mounting them for the first
time.
Note: If you notice a brownish surface on the axles during the first installation of the wheels -
do not be alarmed! - This is a residue of the chrome plating process, which can easily be
wiped off.
NOTE:
Brake:
To engage the brake, push down on the middle of the bar until it grips the wheels (picture
15). To disengage, reverse the procedure (picture 16).
Take care to ensure the brake is DISENGAGED in the boot of the car: due to the heat it's
possible the wheels are irreversibly dented.
Wheels and Brake
Fill pneumatic air wheels with 1.5 bar MAXIMUM.
Please understand that a wheel is a wearing part and is therefor
not included in the warranty of the product. But worn wheels and
also the individual components can be replaced easily and can be
purchased fast in our webshop.
- 21 -